ABB STT04 Instruction Manual page 255

600T & 600T EN PRESSURE TRANSMITTER
Key
CONFIGURATION
→ NEW
C O N F IG
MODIFY
ERASE
E N TE R
DEVICE TYPE
ABB FSK
→ HART
E N TE R
TRANSMITTER TYPE
PTH
TB82 pH
TB82 pION
TZID/AXH
[ 6 TIMES ]
TEU211
50XE4000
50SM'1000 →600T
HART UNIV
E N TE R
STT04 CONFIGURATION
[
E N TE R
←PREVIOUS
SELECT MODE:
→ ANALOG
E N TE R
DIGITAL
MESSAGE:
E N TE R
←PREVIOUS
CREATE/MODIFY CONFIGURATION
Q - 14
Display
Select NEW to create a configuration. To modify an
existing configuration, select MODIFY. The screen
sequence is the same, however, the MODIFY
screens will appear with the values and arrow posi-
tions as they were originally configured.
Select HART.
EBTH
TB82 ORP
TB82 CONC
Select 600T.
AS800
TS11/TS01
50XM2000
Enter a name for the configuration ID tag using up to
eight ASCII characters. To select a character, press
]
the key that has the desired character. Continue to
press the key until the desired character appears.
NEXT→
Use the right arrow key to move to the next charac-
ter. Use the left arrow key to go back to the previous
character.
Select ANALOG.
NOTE: The DIGITAL selection should only be made
when using an IMFBS01 field bus I/O module. A
CHANNEL # prompt appears when DIGITAL is
selected.
Type a descriptive message using up to 32 charac-
ters. This field can be used to note anything of impor-
tance to the device or installation.
NEXT→
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character.
Comments