ABB STT04 Instruction Manual page 46

Key Display
DAMPING
(0 - 32 SEC)
E N TE R
6.00 SEC
LOWER RANGE VAL.
nn.nn UNITS
E N TE R
UPPER RANGE VAL.
nn.nn UNITS
INITIALIZE MODE:
→ LOW
E N TE R
HIGH
FAIL MODE:
→ LOW
E N TE R
HIGH
LAST
SECONDARY L. R.
nn.nn UNITS
E N TE R
SECONDARY U. R.
nn.nn UNITS
LOWER TEMP ALARM
-50.00°C
E N TE R
UPPER TEMP ALARM
120.00°C
MESSAGE:
E N TE R
←PREVIOUS
DESCRIPTOR:
E N TE R
←PREVIOUS
Damping value is displayed to the nearest hundredth
of a second.
Lower and upper range values are displayed.
Indicator points to the configured initialization mode.
Indicator points to the configured fail mode.
Secondary upper and lower range values are
displayed to the nearest hundredth.
Only applies if interfacing a PTS, PTH, EQS or EBTH
transmitter. The upper and lower range temperature
alarm values are shown as configured.
This display appears when configuring HART trans-
mitters only. A message of up to 32 characters can
be entered.
NEXT→
This display appears when configuring HART trans-
mitters only. A descriptor of up to 16 characters can
be entered.
NEXT→
OPERATING PROCEDURES
Comments
GET CONFIGURATION
4 - 9