ABB STT04 Instruction Manual page 208

TB82 TRANSMITTER
Key
CONFIGURATION
→ NEW
C O N F IG
DEVICE TYPE
E N TE R
→ HART
TRANSMITTER TYPE
PTH
E N TE R
→ TB82 pH
TB82 pION TB82 CONC
STT04 CONFIGURATION
[
E N TE R
←PREVIOUS
SELECT MODE:
→ ANALOG
E N TE R
MESSAGE :
E N TE R
←PREVIOUS
DESCRIPTOR:
E N TE R
←PREVIOUS
CREATE/MODIFY CONFIGURATION
N - 2
Display
MODIFY
ERASE
ABB FSK
EBTH
TB82 ORP
]
NEXT→
DIGITAL
NEXT→
NEXT→
Comments
Select NEW to create a configuration. To modify an
existing configuration, select MODIFY. The screen
sequence is the same, however, the MODIFY
screens will appear with the values and arrow posi-
tions as they were originally configured.
Select HART.
Select a TBI device. The configuration shown here is
generalized for all TBI devices. Differences that
occur are noted.
Enter a name for the configuration ID tag using up to
8 ASCII characters. To select a character, press the
key that has the desired character. Continue to press
the key until the desired character appears. Use the
right arrow key to move to the next character. Use
the left arrow key to go back to the previous charac-
ter.
Select ANALOG.
NOTE: The DIGITAL selection should only be made
when using the device in multidrop mode. A CHAN-
NEL # prompt appears when DIGITAL is selected.
Type a descriptive message using up to 32 charac-
ters. Use this field to note important information
about the device or installation.
Type a descriptor string using up to 16 characters.
This field can be used for notations about the device
or process.
To select a character, press the key that has the
desired character. Continue to press the key until the
desired character appears. Use the right arrow key to
move to the next character. Use the left arrow key to
go back to the previous character.