Appendix P - As800 Pressure Transmitter; Introduction; Create/Modify Configuration; Configuration Flowchart (As800 - ABB STT04 Instruction Manual

APPENDIX P - AS800 PRESSURE TRANSMITTER

INTRODUCTION

CREATE/MODIFY CONFIGURATION

This appendix covers the configuration and calibration functions of
the AS800 Pressure Transmitter.
Refer to OPERATING PROCEDURES
the following functions:
Send configurations.
•
Get configurations.
•
View configurations.
•
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
A configuration can be created off-line, without a connected field
device. Refer to Figure
function. The following table details the configuration process.
Figure P-1. Configuration Flowchart (AS800)
The STT04 does not suppport configuration of the AS800 transfer
function or controller function.
in Section 4 for information on
Select configurations.
•
Erase configurations.
•
Operational functions.
•
P-1 for an overview of the configuration
INTRODUCTION
P - 1