Special Advanced; Upgrade Firmware; Upgrade Boot Code; Set Com Port - ABB STT04 Instruction Manual

Special Advanced

6. Click OK.
The following subsections describe the menu items of the Special
Advanced selection.
REPORT DIAGNOSTICS
1. Connect the STT04 terminal to the personal computer.
a. Connect the female end of the RS-232-C (customer supplied)
cable to a vacant RS-232-C port (serial port) on the personal
computer.
b. Connect the male end of the RS-232-C cable to the STT04
terminal.
2. Start the DownLink software. Refer to
tion.
3. Click Special Advanced and select Report Diagnostics. This func-
tion returns the COM port being used, sector status and available
sector status of the STT04 terminal.

UPGRADE FIRMWARE

Refer to UPGRADES in Section 6.

UPGRADE BOOT CODE

This function is seldom needed and should only be performed when
instructed to do so by ABB technical support.

SET COM PORT

Use this function to change the communication port (COM port) on
the personal computer that will be used for communications between
the PC and the STT04 terminal.
1. Start the DownLink software. Refer to
tion.
2. Click Special Advanced and select Set COM Port.
3. Select the desired communication port and click OK.
STT04 DOWNLINK SOFTWARE
Start located in this sec-
Start located in this sec-
USING DOWNLINK SOFTWARE
O - 13