Introduction; Configuration Flowchart (Bcn; Appendix G - Bcn Pressure Transmitter - ABB STT04 Instruction Manual

APPENDIX G - BCN PRESSURE TRANSMITTER

INTRODUCTION

CREATE/MODIFY CONFIGURATION
SELECT
ABB FSK
DEVICE
TYPE
C
O
N
F
I
G
U
R
E
This appendix covers the configuration and calibration functions of the BCN
Pressure Transmitter.
Refer to OPERATING PROCEDURES
following functions:
Send configurations.
•
Get configurations.
•
View configurations.
•
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
A configuration can be created off-line, without a connected field device.
Figure G-1 provides and overview of the configuration process. The follow-
ing table details the configuration process.
SELECT ENTER
TRANSMITTER CONFIGURATION
TYPE ID TAG
ENTER SELECT
DAMPING ENGINEERING
UNITS
VALUE
ENTER ENTER SECONDARY
SECONDARY LOWER/UPPER
UNITS RANGE VALUES
Figure G-1. Configuration Flowchart (BCN)
in Section 4 for information on the
Select configurations.
•
Erase configurations.
•
Operational functions.
•
SELECT
ANALOG
SELECT
OUTPUT
MODE
TYPE
DIGITAL
ENTER 5
ENTER
CHANNEL INPUT/OUTPUT
NUMBER POINTS
ENTER SELECT
LOWER/UPPER INITIALIZE
RANGE VALUES MODE
STORE
CONFIGURATION
SELECT
OTHERS
OUTPUT
ACTION
FUNCTION
GENERATOR
SELECT
FAIL
MODE
T01616A
INTRODUCTION
G - 1