Keypad Functions - ABB STT04 Instruction Manual

OPERATING PROCEDURES
Key
O N
O FF
% & G H I
0 9
+ : /
< > *
E N TE R
C O N F IG
G E T
C O N F IG
S EN D
C O N FIG
C A LI-
B R ATE
M O N ITO R
S TATU S
R E -
R A N G E
OPERATOR/INTERFACE CONTROLS
4 - 2
Table 4-1. Keypad Functions
Powers the unit up and displays the
Turns power off. Stored configurations remain in internal memory. The terminal
will shut itself off after 15 minutes of idle operation.
Scrolls through menus and selects functions.
Inputs values into the terminal. Includes digits 0 through 9, ASCII characters A
through Z, signs, and punctuation.
Completes an input or a selection.
1. Inputs a new configuration into the
2. Modifies an existing configuration.
3. Erases an existing configuration from the terminal memory.
Retrieves, views and optionally saves the configuration of the selected field
device.
Sends a configuration from the STT04 terminal to a selected field device.
Steps through various calibration procedures (dependent on the selected field
device).
Monitors primary input or output, secondary output, ambient temperature of
the selected field device, and other variables.
Displays field device status based on results of continuous self-diagnostics.
1. Changes engineering units.
2. Sets lower and upper range values of primary and secondary units.
3. Changes the output dampening.
Function
STT04
firmware revision level.
STT04
internal memory.