Configuration (Advanced Access Level) - ABB AWT420 Operating Instruction

36 AW T4 2 0 | U N I V E R S A L 4 - W I R E , D U A L- I N P U T T R A N S M I T T E R | O I/A W T4 2 0 - E N R E V. B

13 Configuration (Advanced access level)

Note. Service level menus (not shown) are password-protected at the factory and intended for use by authorized
ABB service technicians only.
See page 37
Calibrate
Refer to the Calibration
section (page 55) for
menu options
See page 38
Sensor Setup
Refer to the relevant sensor
manual for details of sensor
setup menus
See page 38
Device Setup
Configuration of:
• Instrument Tag
• Temperature Units
• Security and Write Protection
See page 39
Display
Configuration of:
• Language
• Operating, View and Log modes
• Time and Date
Figure 31 Configuration (Advanced access level) overview
See page 41
Input/Output
Configuration of:
• Analog outputs
• Digital I/O
• Relay outputs
• Sensor clean functions
See page 43
Process Alarm
Configuration of:
• Process alarms
See page 44
Media Card
C onfiguration of:
• Data logging
• Load and save of configurations
See page 45
Control
Configuration of:
• PID control of measured process
See page 47
Communication
Refer to communications manuals:
• COM/AWT420/HART-EN
• COM/AWT420/MODBUS-EN
• COM/AWT420/PROFIBUS-EN
• COM/AWT420/ETHERNET-EN
for details of HART, MODBUS, Profibus
and Ethernet connections/configuration
See page <OV>
Device Info
Information relating to:
• Serial number
Software and hardware revisions
• Sensor information