Replacement Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

Hard Disk Drive Replacement Option 019
Replacement Procedure
Step 1. Paste the heat transfer sheet to the hard disk drive rear side.
Figure 6-11 Removable Hard Disk Drive Removal Option 019
Step 2. Replace the hard disk drive by inverse procedure of removal.
Fasten the TORX T10 screws (item 3) using a torque driver.
Step 3. Restore backup files onto the new removable hard disk drive as described in
"Restore Backup Files onto the New Hard Disk Drive" on page
Step 4. Calibrate the touch screen as described in
on page
Keysight E5071C ENA Network Analyzers
208.
207.
"Calibration of the Touch Screen"
215