Digital Bridge Board Replacement (A53); Tools Required; Removal Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

Digital Bridge Board Replacement (A53)

Digital Bridge Board Replacement (A53)

Tools Required

•

Removal Procedure

Refer to
Step 1. Remove the outer cover as described in
Step 2. Remove the three TORX T10 screws (item 1) fastening the angle.
Step 3. Disconnect the flat cables (item 2) from the digital bridge board.
Step 4. Remove the two TORX T10 screws (item 3) fastening the board to the rear
panel.
Step 5. Lift the digital bridge board (item 4).
Step 6. Disconnect the cables (item 5) from the digital bridge board.
Step 7. Remove the two TORX T10 screw (item 6) fastening the angle.
220
TORX screwdriver, T10, T15, and T20
Figure 6-14 for this procedure.
"Outer Cover Removal" on page
Keysight E5071C ENA Network Analyzers
203.