Control Touch Panel Replacement; Tools Required; Removal Procedure; Replacement Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

Control Touch Panel Replacement

Control Touch Panel Replacement

Tools Required

•
•

Removal Procedure

Refer to
Step 1. Remove the outer cover as described in
Step 2. Remove the front panel as described in
Step 3. Disconnect the cables (item 1, 2) connected through the cover.
Step 4. Remove the two TORX T10 screws (item 3) fastening the control touch panel.
Figure 6-39 Control Touch Panel Replacement
Replacement Procedure
Step 1. Replace the control touch panel by inverse procedure of removal.
Keysight E5071C ENA Network Analyzers
TORX screwdriver, T10, T15, and T20
Flat edge screwdriver
Figure 6-39 for this procedure.
"Outer Cover Removal" on page
"Front Panel Removal" on page
203.
204.
271