10 Mhz Oven Board (Opt. 1E5) Replacement (A5); Tools Required; Removal Procedure; Replacement Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

10 MHz Oven Board (Opt. 1E5) Replacement (A5)

10 MHz Oven Board (Opt. 1E5) Replacement (A5)

Tools Required

•

Removal Procedure

Refer to
Step 1. Remove the outer cover as described in
Step 2. Remove the six TORX T10 screws (item 1) fastening the rear cover.
Step 3. Release the clamped cables from the clamps (item 2) on the rear cover.
Step 4. Disconnect the cables (item 3, 4) from the oven.
Step 5. Remove the three TORX T10 screws (item 5) fastening the oven.
Figure 6-36 10 MHz Oven Board Removal
Replacement Procedure
Step 1. Replace the 10 MHz oven board by inverse procedure of removal.
Keysight E5071C ENA Network Analyzers
TORX screwdriver, T10, T15, and T20
Figure 6-36 for this procedure.
"Outer Cover Removal" on page 203.
267