Removable Hard Disk Assembly Removal (Obsolete); Tools Required; Removal Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

Removable Hard Disk Assembly Removal (Obsolete)

Removable Hard Disk Assembly Removal (Obsolete)

Tools Required

•
•

Removal Procedure

Refer to
Step 1. Remove the outer cover as described in
Step 2. Remove the front panel as described in
Step 3. Disconnect the two cables (item 1).
Step 4. Remove the three TORX T10 screws (item 2) fastening the removable hard
disk assembly.
Step 5. Be careful to release the hook from chassis (item3) and lift the removable
hard disk assembly.
Step 6. Remove the four TORX T10 screws (item 4) fastening the bracket.
Figure 6-3 Removable Hard Disk Assembly Replacement (Obsolete)
Keysight E5071C ENA Network Analyzers
TORX screwdriver, T10, T15, and T20
Flat edge screwdriver
Figure 6-3 for this procedure.
"Outer Cover Removal" on page
"Front Panel Removal" on page
203.
204.
205