Hard Disk Assembly Removal Option 019; Tools Required; Removal Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

Hard Disk Assembly Removal Option 019

Hard Disk Assembly Removal Option 019

Tools Required

•
•

Removal Procedure

Refer to
Step 1. Remove the outer cover as described in
Step 2. Remove the front panel as described in
Step 3. Disconnect the two cables (item 1).
Step 4. Remove the four TORX T10 screws (item 2) fastening the hard disk assembly.
Step 5. Lift the hard disk assembly (item 3).
Step 6. Remove the two TORX T10 screws (item 4) fastening the bracket.
Step 7. Remove a TORX T10 screw (item 5) fastening the bracket.
Step 8. Be careful to release the hook from chassis (item 6) and lift the bracket (item
7).
Figure 6-9 Removable Hard Disk Assembly Replacement Option 019
Keysight E5071C ENA Network Analyzers
TORX screwdriver, T10, T15, and T20
Flat edge screwdriver
Figure 6-9 for this procedure.
"Outer Cover Removal" on page
"Front Panel Removal" on page
203.
204.
213