Removable Hard Disk Assembly Removal (Option 017); Tools Required; Removal Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

Removable Hard Disk Assembly Removal (Option 017)

Removable Hard Disk Assembly Removal (Option 017)

Tools Required

•
•

Removal Procedure

For units with serial number prefix MY461 or SG461, refer to
procedure.
For units with serial number prefix MY462/MY463 or SG462/SG463, refer to
Figure 6-7
Step 1. Remove the outer cover as described in
Step 2. Remove the front panel as described in
Step 3. Disconnect the two cables (item 1).
Step 4. Remove the three TORX T10 screws (item 2) fastening the removable hard
disk assembly.
Step 5. Be careful to release the hook from chassis (item3) and lift the removable
hard disk assembly.
Step 6. Remove the four TORX T10 screws (item 4) fastening the bracket.
Keysight E5071C ENA Network Analyzers
TORX screwdriver, T10, T15, and T20
Flat edge screwdriver
for this procedure.
Figure 6-6
"Outer Cover Removal" on page
"Front Panel Removal" on page
for this
203.
204.
209