Required Adjustment After Replacing Assembly - Keysight E5071C ENA Service Manual

Adjustment

Required Adjustment after Replacing Assembly

Required Adjustment after Replacing Assembly
After replacing the following assembly, the adjustment items described in
Table 3-1
qualified service personnel. If you need the adjustment for your E5071C, it
should be sent to the nearest Keysight Technologies service office.
Required Adjustment Item after Replacing Assembly
Table 3-1 Up to 8.5 GHz Options
Replaced Assembly
Reference Oven
Board (OCXO)
Analog Base Module
(BAS)
Synthesizer Module
for Source
(SYN-SRC)
Synthesizer Module
for Local (SYN-LCL)
Level Vernier Module
(VNR)
Receiver Module
(RCV)
Hard Disk Drive
(HDD)
Distributor Module
(DIS)
RF Switch (T2-SW)
58
must be required. The adjustment must be performed Keysight's
Adjustment Item
√
√
√
√
√ √
√ √
√
√ √ √
√
√
Keysight E5071C ENA Network Analyzers
√ √ √
√ √
√ √