Performance Test
Introduction
Test Equipment Required
The required equipment for the performance test is listed on
1-3,
Table 1-4
performance test.
For the latest ETE lists, refer to Keysight Test Management Environment
(TME) Software Portal. The complete ETE lists are available in E5071C
Calibration Application WebHelp.
Softkey Selection Procedure for Performance Test
The procedure of the softkey selection depends on the firmware revision.
Note that some softkey selection procedures for your E5071C might be a
little bit different from the procedure described in this chapter.
Keysight E5071C ENA Network Analyzers
and
Table
1-5. Use only calibrated equipment when doing the
http://cal.software.keysight.com/
Table
1-2,
Table
41