Keysight E5071C ENA Service Manual page 344

Messages
Error Messages
function is turned OFF, (SENS:CORR:COLL :ECAL:ORI OFF), however, this error
does not occur even when the port on the ECal module is not connected
correctly to the instrument.
-200 Execution error
An error associated with execution has been generated for which this
instrument cannot specify the error message. This code shows that an error
associated with execution defined in 11.5.1.1.5, IEEE488.2 has occurred. This
error occurs also when a calibration measurement is aborted.
-123 Exponent too large
The absolute value of the exponent exceeds 32,000 (see 7.7.2.4.1, IEEE488.2).
-178 Expression data not allowed
An expression-data element has been received at a position where this
instrument does not accept one.
-170 Expression error
When the expression data is put to syntactic analysis, an error not
corresponding to one of Error Numbers -171 through -179 occurs.
502 Equation run time error
This error occurs under the following conditions:
The trace number in data(tr)/mem(tr)/xAxis(tr) is out of range
# of trace available depends on the maximum number of channel/traces
The port number in Advanced math function is out of range
# of port available depends on the model option
F
31 Failed to configure ECal module
This error occurs when the control of the ECal module fails at time of executing
an ECal command, SENS:CORR:COLL:ECAL:SOLTn or
SENS:CORR:OFFS:COLL:ECAL :xxxx. The failure results from the failure to
connect the ECal module to the USB port, failure of the ECal module, etc.
76 Failed to control signal generator
This error occurs when the external signal source fails to respond during
measurement, though it is enabled (SENS:OFFS:LOC:STAT ON and
SENS:OFFS:LOC:CONT ON).
Ensure the connection of the external signal source.
102 Failed to copy file
This error occurs when copying a file (MMEM:COPY command) fails.
344
Keysight E5071C Service Manual