Keysight E5071C ENA Service Manual page 26

General Information
Required Equipment
Table 1-2 Recommended Test Equipment
Equipment
Adapter
Torque
Wrench
Personal
Computer with
GPIB board
Table 1-3 Alternative Test Equipment
Equipment
Frequency
Counter
Multimeter
Function
Generator
Power Sensor
Short
Load
For the latest ETE lists, refer to Keysight Test Management Environment
(TME) Software Portal. The complete ETE lists are available in E5071C
Calibration Application WebHelp.
26
Critical specifications
N(m)-3.5mm(f)
Size: 20 mm
Torque: 90 N-cm
Windows XP, VEE7.5 or later
1. P: Performance Tests, A: Adjustment, T: Troubleshooting
2. The accuracy of a standard E4419A/B of 0.02 dB is adequate for all tests/adjust-
ment except "Dynamic Accuracy Test". This test requires a power meter with Option
G12 or H12 that has been certified to a higher accuracy specification. If an Option
G12 or H12 power meter is not available, a test is provided on
Accuracy Test" on page 31
Critical specifications
Frequency: 50MHz to 8.5GHz
Accuracy: < 2.5 ppm
No Substitute
Type-N(m)
Type-N(m)
1. P: Performance Tests, A: Adjustment, T: Troubleshooting
Recommended Model
Keysight p/n
1250-2879
Keysight p/n
8710-1764
to verify the accuracy of a standard power meter.
Model
Keysight 53131/2A
with Opt.010 and 124
Keysight 34401A
Keysight 34410A
Keysight 34411A
Keysight 33220A
Keysight 33250A
Keysight E9304A with
Opt. H19
Keysight 11512A
Keysight 909F
Opt. 012
http://cal.software.keysight.com/
Keysight E5071C ENA Network Analyzers
Qty
1
Use
2 P
1 P,A
1 P,A
"Power Meter
Qty
1
Use
1 P,A
1 P,T
1 P,T
1 P,T
1 P,T
1 P,T
1 P,A
4 P,T
4 P