Front Panel Removal; Tools Required; Procedure - Keysight E5071C ENA Service Manual

Replacement Procedure

Front Panel Removal

Front Panel Removal

Tools required

•
•

Procedure

Refer to
Step 1. Remove the outer cover as described in
Step 2. Remove the top trim (item 1) using a flat edge driver.
Step 3. Remove the seven TORX T15 screws (item 2 ) fastening front panel.
Step 4. Release the cable (item 3) from the cable clamp (item 4).
Step 5. Release the two cable (item 6) from the cable clamp (item 5).
Step 6. Gradually push the front panel assembly towards the outside.
Figure 6-2 Front Panel Removal
204
TORX screwdriver, T10, T15, and T20
Flat edge screwdriver
Figure 6-2 for this procedure.
"Outer Cover Removal" on page
Keysight E5071C ENA Network Analyzers
203.