Keysight E5071C ENA Service Manual page 355

Messages
Error Messages
-158 String data not allowed
A character-string-data element has been received at a position where this
instrument does not accept one.
-138 Suffix not allowed
A suffix is attached to a numeric value element to which a suffix is not allowed
to be attached.
-134 Suffix too long
The unit is too long.
The unit is expressed in 12 or more characters (see 7.7.3.4, IEEE488.2).
55 Sweep mode changed to stepped sweep
You cannot change the sweep mode to the swept mode.
This error occurs when you change the sweep mode to the swept mode/high
speed swept mode under the conditions where the sweep type is set to power
sweep, power slope function is enabled (ON, correction coefficient is other
than zero), power calibration is ON, frequency offset is enabled, spurious
avoidance of frequency offset is enabled, or external signal source control is
enabled.
-102 Syntax error
A command or data type that is not recognized exists.
-310 System error
One of the errors designated as "system errors" in this instrument has
occurred.
T
40 Target value not found
This error occurs when the target is not found during the marker search
analysis after specifying the target and executing the CALC:MARK:FUNC:EXEC
and CALC:FUNC:EXEC commands. This error occurs also when the bandwidth
is not found after executing the bandwidth marker command,
CALC:MARK:BWID:DATA?
-124 Too many digits
The number of digits of the argument of the decimal numeric-value-data
element exceeds 255 with the preceding 0 removed (see 7.7.2.4.1, IEEE488.2).
Keysight E5071C Service Manual -355