Teach In Rapid Traverse G0; Teach In Straight G1 - Siemens SINUMERIK 840D sl Operating Manual

Teaching in a program
5.3 Inserting a block
...
5.3.1.2

Teach in rapid traverse G0

You traverse the axes and teach-in a rapid traverse block with the approached positions.
Note
Selection of axes and parameters for teach-in
You can select the axes to be included in the teach-in block in the "Settings" window.
You also specify here whether motion and transition parameters are offered for teach-in.
5.3.1.3

Teach in straight G1

You traverse the axes and teach-in a machining block (G1) with the approached positions.
Note
Selection of axes and parameters for teach-in
You can select the axes to be included in the teach-in block in the "Settings" window.
You also specify here whether motion and transition parameters are offered for teach-in.
136
6. Press the softkeys "Rap. tra. G0", "Straight line G1", or Circ. interm.
pos. CIP" and "Circ. end pos. CIP".
The relevant windows with the input fields are displayed.
7. Traverse the axes to the relevant position.
8. Press the "Accept" soft key.
A new program block will be inserted at the cursor position.
- OR -
Press the "Cancel" softkey to cancel your input.
Operating Manual, 01/2008, 6FC5398-6AP10-2BA0
HMI sl Universal