Preparation; Switching On; Traverse To Reference Point - Siemens SINUMERIK 810M Operating And Programming Manual

3 Operating Sequences

3.1 Switching on

3.1

Preparation

3.1.1 Switching on
When you switch the control and machine on:
Follow the instructions in the machine tool
3.1.2

Traverse to reference point

After switching on you traverse the individual axes to the reference points. This synchronizes
the control with the machine.
The position of the reference point and the traversing
rate are set in machine data by the machine tool
Sequence of operation
REF-
POINT
You select the "REFPOINT" operating mode via softkey
You set the operating mode selector switch on the external machine
control panel to this symbol (REFPOINT).
3-2
manufacturer's documentation!
manufacturer!
© Siemens AG 1990 All Rights Reserved
or
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)
11.90