Entering Sleep Mode - Canon imageRUNNER ADVANCE C5560i III User Manual

Entering Sleep Mode

The sleep mode function reduces power consumption by temporarily disabling some internal operations of the
machine. You can put the machine into sleep mode simply by pressing
in sleep mode, the touch panel display turns off and
● The machine may not enter sleep mode depending on the machine's operation status and conditions.
● You can set the order for starting necessary functions when you perform operations after exiting sleep
mode. <Sleep Mode Eco Exit>(P. 1050)
● The Processing/Data indicator flashes or maintains a steady green light even when the machine enters the
Sleep mode.
Exiting Sleep Mode
If <Use Motion Sensor> (Settings/Registration) is set to <On>, the machine exits sleep mode automatically when
a person is nearby. If the machine does not exit sleep mode, press
● For information on the location of the motion sensor, see
● When the sleep mode is canceled by the motion sensor and no operation is performed within 60
seconds, the machine enters the sleep mode again even though the Auto Sleep time has not elapsed.
● If <Use Motion Sensor> is set to <Off>, the machine exits the sleep mode when one of the following
operations is performed:
- When the Energy Saver key is pressed on the control panel
- When originals are placed in the feeder
- When the feeder is opened
- When paper is loaded in/removed from the multi-purpose tray
- When a cover on the machine is opened/closed
- When an IC card is held over an IC card reader installed to the machine to log in
*1 Some models of the machine do not support this function.
*2 Applicable only when <Sleep Mode Energy Use> is set to <High>.
When You Want to Set the Auto Sleep Timer
You can use the <Auto Sleep Time> setting to automatically put the machine into sleep mode. If you want to
change the amount of time that elapses before the machine enters auto sleep mode, follow the procedure
below.
<Preferences>
amount of time that elapses before the machine automatically enters sleep mode
Basic Operations
lights up.
*1
<Timer/Energy Settings>
216
on the control panel. When the machine is
Control Panel(P. 103)
. <Use Motion Sensor>(P. 1050)
Front Side(P. 92) .
*1
*1
<Sleep Mode Energy Use>(P. 1049)
<Auto Sleep Time>
4XR3-03A
*2
or to set the
<OK>.