Canon imageRUNNER ADVANCE C5560i III User Manual page 242

You can select the type of sending results that are displayed when
you want to check whether an I-fax is delivered to the recipient's machine, or select <Simple> if you
want to check whether an I-fax is delivered to a mail server. Note that you cannot confirm the delivery
status if the recipient's machine does not support the <Mode:> function.
● If you send an I-fax using the <Full> mode to a machine that does not support the <Full> mode,
<Awaiting result...> is displayed when you press
transmission is complete. It continues to be displayed until the time set in
Mode TX Timeout> passes.
● You can check the delivery status by pressing
sent successfully, <OK> will be displayed, if it failed to send, <NG> will be displayed, and if the
results cannot be confirmed, <--> will be displayed. In the Simple mode, even if the delivery was
successful, <--> will be displayed because delivery confirmation cannot be carried out.
2
Press <Destination Conditions>
<Paper Size>
Set the paper size that the recipient can receive. Specify this setting after checking whether the paper
size of the data to send matches the specifications of the recipient's device.
- <A4/LTR>: Sends with the A4/LTR size.
- <A4/LTR> + <B4>: Sends with the A4/LTR size or B4 size.
- <A4/LTR> + <A3/11x17>: Sends with the A4/LTR size or A3/11" x 17" size.
- <A4/LTR> + <B4> + <A3/11x17>: Sends with the A4/LTR size, B4 size, or A3/11" x 17" size.
● If the paper size of the scanned data is smaller than the sizes set in <Paper Size>, the data is sent
with the smallest paper size set in <Paper Size> with blank margins.
● If the paper size of the scanned data is larger than the sizes set in <Paper Size>, the data is reduced
and sent with the largest paper size set in <Paper Size>.
● Set the destination conditions according to the specifications of the recipient's machine. If the paper
size of the data to send is larger than the paper sizes that can be used with the recipient's device,
the image may be clipped or cut off.
<Compression Method>
Select compression method. The compression rate is highest for MMR, followed by MR, and then MH.
The higher the compression rate, the shorter the required transmission time.
<Resolution>
Select a higher value to increase the resolution and image quality. However, the higher the resolution,
the longer the required transmission time.
<Divide Data>
If the size of the data being sent exceeds the maximum limit (
Sending>(P. 1102) ), select whether you want to divide the data by size or by page.
Basic Operations
specify each setting and press <OK>.
228
is pressed. Select <Full> if
to check the delivery status, even if the
<Send>(P. 1095)
<Send> <Job Log>. If the document was
<Maximum Data Size for
<Full