Canon imageRUNNER ADVANCE C5560i III User Manual page 353

Framing
Blanking
9
Confirm whether the areas are specified correctly, and press <OK>.
● To adjust an area, press <OK> to return to step 7, press <Clear Area> or <Fine Adjust>, and specify the area
again.
If you select <Blanking> in step 8, press <OK> and proceed to step 12.
10
Press <Next >
● To move the specified area to the center of the paper, press <Center Shift>.
11
Press <OK>.
12
Press .
➠
Copying starts.
Specifying more complicated areas
You can specify areas with a complicated shape, as indicated in the diagram below. Press <Enter Multipoints>
on the screen in step 7, and specify the area using 4 to 10 points. After pressing the last point, press <Set
Multipoints> to confirm the area. When using this method, you can only specify one area. In addition, you
cannot designate a rectangular area and a polygonal area at the same time.
Specifying a more accurate area
Copying
<Center Shift> or <Do Not Center Shift>.
339