Belt Tension Specification; Bolt Grade Identification - Precor Experience Series Service Manual

System Component
1
RF coax connector
Display fasteners
Set screws
Plastite screw fasteners
Flathead screws
Input Drive Assembly fastener
Step-up Pulley/Tensioner and Tension Assy fasteners
Generator/Eddy Brake Assy fasteners
Linkarm fasteners
Crank Retention Plate Fastener
Yoke Ramp bolts
Belt Tension Specification
.Drive belt tension specification:
System Component
First Stage Drive Belt Tension - New Belt
First Stage Drive Belt Tension - Used Belt
Second Stage Drive Belt Tension - New Belt
Second Stage Drive Belt Tension - Used Belt
(1) New belt tension applies to new belt first time installations. Used belt tension applies
to reinstalling an existing belt or re-tensioning an existing used belt.
.

Bolt Grade Identification

1
Radio Frequency: Identifies electromagnetic signals with frequency spectrum between the
3 kHz (3,000 hertz) to 300 GHz (300 billion hertz) range.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
2.4 in-lbs (0.271 Nm)
180 in-lbs (20 Nm
300 in-lbs (34 Nm)
20 in-lbs (2.3 Nm)
25 in-lbs (2.8 Nm)
180 in-lbs (20.3 Nm)
180 in-lbs +/- 54 (20.3 +/_ 4.5
Nm)
180 in-lbs +/- 54 (20.3 +/_ 4.5
Nm)
300 +/- 90 in-lbs (34 +/- 10 Nm)
30 +/- 9 in-lbs (3.4 +/- 1 Nm)
330 in-lbs (27.5 ft-lbs or 37.2
Nm)
(1)
140-150 lbs (63.5 - 68 kgs)
(1)
125 - 135 lbs (56.7 - 61 Kgs)
(1)
110-120 lbs (50- 54.4 kgs)
(1)
92 - 105 lbs (43 - 47.6 kgs)
2 General Information
Bolt Grade Identification
Specification
Specification
Page 10