Removing The I/O-Ipc From The Mounting Rail; Figure 14: Removing The I/O-Ipc From The Mounting Rail - WAGO -I/O-SYSTEM 750 User Manual

6.6.2

Removing the I/O-IPC from the Mounting Rail

Remove the I/O-IPC from the mounting rail as described below:
1. First, disconnect from the power supply those parts of the system on which
you have mounted the I/O-IPC.
2. Then, pull the orange release tab (24) to remove the first 750 Series I/O
Module connected to the I/O-IPC from the mounting rail (A and B).
3. Press the four release levers (23) with both hands at the same time until they
stop and then remove the I/O-IPC from the mounting rail (C).
A
B
C

Figure 14: Removing the I/O-IPC from the mounting rail

WAGO I/O-SYSTEM 750
I/O-IPC-C10E, CANopen Master
Installing and Removing the I/O-IPC
23
23
24
...
24
...
...
41