Removing A Head Station From The Din-Rail - WAGO 750 Series System Manual

Serie 750, 753
Attaching the 753 Series Wiring Interface
1. Make sure that the locking tab of the I/O module is not pulled out.
2. Put the wiring interface on the I/O module.
3. Press the wiring interface onto the I/O module until it clicks into place completely.

6.4 Removing a Head Station from the DIN-Rail

Follow these steps to remove a head station from a DIN-rail:
1. Use an operating tool to turn the DIN-rail locking cam until the nose of the DIN-rail
locking cam disengages from the DIN-rail.
System manual | Version: 3.0.2
Assembly and Disassembly
Figure 24: 753 Series Wiring Interface and I/O Module
Figure 25: Disengage the locking cam
45