Canister Component - Honda CB HORNET 160R 2015 Shop Manual

INSPECTION
Air must flow from bigger opening (from canister) to smaller
opening (to carburetor) not in reverse direction.
• Don't use compressed high pressure air for
inspection.
• Don't drop the one way valve, if dropped replace.
Connect one way valve to the hoses with its arrow mark
facing upwards.

CANISTER COMPONENT

REMOVAL/INSTALLATION
Remove the both side covers (page 2-3).
Disconnect the hoses from right side from the canister
component.
Remove the starter motor cable (page 10-8).
Pull out the canister from its stay.
INSPECTION
check for cracks or fissures on the body of the canister
component and replace if necessary if falling out of
emission norms.
Installation is in the reverse order of removal.
• The canister must be installed at its original position
to avoid damage of performance.
• Do not bend, twist or kink the tube.
AIR FLOW
VACUUM HOSE
HOSE
STARTER MOTOR
CABLE
CANISTER
RIGHT SIDE
HOSE CONNECTOR IDENTIFICATION
FUEL SYSTEM
SMALLER DIA
ONE WAY
VALVE
CANISTER
CANISTER
HOSE
CANISTER
LEFT SIDE
5-21