Gearshift Linkage - Honda CB HORNET 160R 2015 Shop Manual

CLUTCH/GEARSHIFT LINKAGE
Clean the inside of the oil filter rotor.
Install the oil filter rotor and washer onto the crankshaft.
Apply clean engine oil to the threads and seating surface of
the lock nut and install it with the chamfered side facing in.
Install the gear holder between the primary drive and driven
gears as shown, and tighten the oil filter rotor lock nut to
the specified torque using the special tools.
TOOLS:
Gear holder
TORQUE:83 N·m (8.3 kgf·m, 61 lbf·ft)
Install the following:
– Oil filter rotor cover (page 3-13)
– Right crankcase cover (page 9-5)

GEARSHIFT LINKAGE

REMOVAL
Remove the following:
– Clutch assembly (page 9-6)
Pull out the gearshift spindle from the crankcase.
Remove the thrust washer.
Remove the gearshift cam bolt by using special tool.
TOOL:
Holder gear drum stopper arm 070SRTKSP010
Remove the gearshift cam.
9-12
07006-KRBT900
LOCK NUT
LOCK NUT WRENCH
GEAR HOLDER
GEARSHIFT SPINDLE
THRUST WASHER
BOLT
GEARSHIFT CAM
HOLDER GEAR DRUM
STOPPER ARM
OIL FILTER ROTOR
WASHER
LOCK NUT