Rear Disk Brake Pad Replacement - Honda CB HORNET 160R 2015 Shop Manual

INSTALLATION
Install the brake caliper to the right fork leg so that the disc
is positioned between the pads.
Be careful not
Install and tighten new brake caliper mounting bolts to the
to damage the specified torque.
pads.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Install the brake hose to the brake caliper with the oil bolt
and new sealing washers.
Rest the hose joint onto the stoppers, and tighten the oil
bolt to the specified torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the brake pads (page 14-7).
Fill the brake fluid, and bleed the air for the hydraulic
system (page 14-4).
REAR BRAKE

REAR DISK BRAKE PAD REPLACEMENT

Check the fluid
Push the caliper pistons all the way in by pushing the
level in the
caliper body inward to facilitate installation of new brake
master cylinder
pads.
reservoir as
this operation
causes the fluid
level to rise.
Always replace
Drive out the pad pin from the brake caliper.
the brake pads
Check the pad pin for abnormal wear or distortion, replace
in pairs to
them if necessary.
assure even
disc pressure.
Do not operate
Remove the brake pads.
the front brake
lever after the
brake pads are
removed.
BRAKE
HOSE
SEALING
OIL BOLT
WASHERS
REAR BRAKE
PAD PIN
BRAKE PAD
BRAKE SYSTEM
BOLTS
14-19