Honda CB HORNET 160R 2015 Shop Manual page 126

CYLINDER HEAD/VALVES
INSPECTION
Check the lifter operation:
• The tensioner shaft should not go into the body when
it is pushed.
• When it is turned clockwise with a stopper tool
(page 7-6), the tensioner lifter shaft should be pulled
into the body. The shaft spring out of the body as soon
as the stopper tool is released.
INSTALLATION
Turn the tensioner lifter shaft clockwise with the stopper
tool to retract the tensioner lifter, then insert the stopper
fully to hold the tensioner lifter in the fully retracted position.
Install a new gasket on the cam chain tensioner lifter.
TOOL:
Tensioner lifter stopper
Install the cam chain tensioner lifter.
Install the two mounting bolts and tighten them.
Remove the stopper tool from the tensioner lifter.
Apply clean engine oil to a new O-ring and install it to the
lifter.
Install the tensioner lifter plug pan screw and tighten it to
the specified torque.
TORQUE: 4 N·m (0.4 kgf·m, 3.0 lbf·ft)
7-22
STOPPER TOOL
070MG-0010100
TENSIONER LIFTER
TENSIONER LIFTER
TENSIONER LIFTER
GASKET
BOLTS
O-RING
PAN SCREW