Honda CB HORNET 160R 2015 Shop Manual page 143

Install the clutch lifter piece into the clutch lifter arm groove
by aligning the groove with the lifter piece hole.
INSTALLATION
Clean off any gasket material from the mating surfaces of
Be careful not
the right crankcase and cover.
to damage the
mating surfaces.
Install the dowel pins and new gasket.
Install the right crankcase cover, clutch cable holder and
right crankcase cover bolts.
Tighten the right crankcase cover bolts in a crisscross
pattern in 2 or 3 steps.
TORQUE: 9 N·m (0.9 kgf·m, 6.6 lbf·ft)
Install the kick start stopper and tighten the bolts/nuts
(2 nos.).
Connect the clutch cable to the clutch lifter arm.
Adjust the clutch lever free play (page 3-22).
Install the following:
– Kick starter pedal (page 6-6)
Fill the crankcase with the recommended engine oil
(page 3-10).
CLUTCH/GEARSHIFT LINKAGE
DOWEL PINS
HOLDER
KICK
START
STOPPER
BOLTS
LIFTER ARM
ADJUSTING NUT
LIFTER PIECE
RETURN SPRING
GASKET
COVER
BOLTS
CLUTCH CABLE
LOCK NUT
9-5