Wheel Rim; Brake Disc - Honda CB HORNET 160R 2015 Shop Manual

WHEEL RIM

Check the wheel rim runout by placing the wheel in a
turning stand.
Turn the wheel by hand and read the runout using a dial
indicator.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMITS:
Axial: 0.3 mm (0.01 in)
Radial: 0.3 mm (0.01 in)

BRAKE DISC

Check the wheel rim runout by placing the wheel in a
turning stand.
Spin then wheel by hand, and read the runout using a dial
indicator.
SERVICE LIMITS:
Runout: 0.10 mm (0.004 in)
WHEEL BALANCE
Carefully check balance before installing the wheel.
The wheel balance must be checked when the tire is
remounted.
For optimum balance the tire balance mark (light mass
point: a paint dot on the side wall) must be located next to
the valve stem. Remount the tire if necessary.
Note the rear direction marks on the tire, and upon tire
installation, always fit the tire so the marks face the same
direction.
DISASSEMBLY
Place the wheel
Remove the dust seal from the right wheel hub.
on a wooden
Loosen the brake disc mounting bolts in a crisscross pattern
platform. Do not
in 2 or 3 steps, and remove the brake disc.
reuse the bolts.
Never install Install the bearing remover head into the bearing.
the old bearing,
From the opposite side, install the bearing remover shaft,
once the
and drive out the bearing from the wheel hub.
bearing has
been removed, Remove the distance collar, and drive out the other bearing.
the bearing
TOOLS:
must be
replaced with
Bearing remover head, 15 mm
new one.
Bearing remover shaft
FRONT WHEEL/SUSPENSION/STEERING
WHEEL RIM
TYRE BALANCE MARK
BEARING
07746-0050400
07746-0050100
REMOVER HEAD
DISC RUNOUT
VALVE STEM
BRAKE DISC
DUST SEAL
FRONT
DIRECTION
MARK
BOLTS
REMOVER SHAFT
12-11