Honda CB HORNET 160R 2015 Shop Manual page 98

ENGINE REMOVAL/INSTALLATION
ENGINE REMOVAL
Support the motorcycle on its center stand.
Drain the engine oil (page 3-11).
Remove exhaust pipe/muffler (page 2-8)
Disconnect the following:
– Spark plug cap (page 3-7)
– Clutch cable (page 9-6)
– Carburetor (page 5-6)
– ASV air supply hose (page 3-14)
Disconnect the neutral switch wire connector, ignition
pulse generator wire connector, alternator 2P (white)
connector and VS sensor connector (3 nos.). Disconnect
the crankcase breather hose.
Disconnect the 2 terminals of the starter motor by removing
nut and bolt.
Replace the bolt and nut after disconnecting the terminal.
Loosen the rear axle nut.
Loosen the both side drive chain adjusting lock nut and
adjusting nut.
Push the rear wheel forward and make a drive chain slack
fully.
Remove the kickstarter pedal pinch bolt and kickstarter
pedal.
6-2
VS SENSOR
CONNECTORS
IGNITION PULSE
GENERATOR
CONNECTOR
TERMINALS
BOLTS
AXLE NUT
ADJUSTING NUT
LOCK NUT
PINCH BOLT
NEUTRAL SWITCH
WIRE CONNECTOR
2P (WHITE)
CONNECTOR
NUT
AXLE SHAFT
LOCK NUT
KICKSTARTER
PEDAL