Honda CB HORNET 160R 2015 Shop Manual page 241

REAR WHEEL/SUSPENSION
Apply grease to the collars surface and install them into
swing arm pivots.
COLLARS
Apply grease to the dust seal.
DUST SEAL
Install the dust seal.
Install the chain slider while aligning the bosses (3 nos.)
with tabs.
DUST
SEAL
BOSSES
CHAIN SLIDER
INSTALLATION
LEFT SIDE VIEW RIGHT SIDE VIEW
Install the swingram pivot bolt and nut.
Tighten the pivot nut to the specified torque.
TORQUE: 54 N.m (5.5 kgf.m, 40 Ibf.ft)
PIVOT BOLT
PIVOT NUT
13-17