Honda CB HORNET 160R 2015 Shop Manual page 313

REMOVAL
Remove the left crankcase rear cover (page 11-4).
Disconnect the neutral switch connector.
Remove the neutral switch mounting bolts (2 nos.) .
Remove the neutral switch and O-ring.
Remove the drive piece and spring.
INSTALLATION
Check the drive piece and spring for wear or damage,
replace them if necessary.
• Bending the drive piece by forcing or crushing the
contact point will cause poor electricity connection.
Install the spring and drive piece.
LIGHTS/METERS/SWITCHES
BOLTS
NEUTRAL SWITCH
O-RING
NEUTRAL SWITCH
DRIVE PIECE
SPRING
DRIVE PIECE
SPRING
17-13