Rear Wheel/Suspension Contents - Honda CB HORNET 160R 2015 Shop Manual

COMPONENT LOCATION
SERVICE INFORMATION
TROUBLESHOOTING
REAR WHEEL
SERVICE INFORMATION
GENERAL
Frequent inhalation of brake pad (shoe) dust, regardless of material composition could be hazardous to your health.
• Avoid breathing dust particles.
• Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
• Riding on damaged rims impairs safe operation of the vehicle.
• When servicing the rear wheel and suspension, support the vehicle using a center stand or hoist.
• A contaminated brake drum or shoe reduces stopping power. Discard contaminated shoes, and clean a contaminated drum
with a high quality brake degreasing agent.
• After the rear wheel installation, check the brake operation by applying the brake pedal.
• Refer to the brake system information (page 14-1).
• This vehicle is equipped with the TUBELESS tyre.
• The TUBELESS tyres does not use any inner tube, its inner layer (inner liner ) used as instead of tube. Only tubeless tyre is
mounted on the rim. Follow bellow caution:
– Loose the tyre bid from rim with the help of bid breaker. Demount the tyre using a tyre demounting machine.
– In nail hole puncture case drill the puncture hole to make the inner surface of the puncture hole smooth & to remove
contamination
– In pin hole puncture case mark the puncture hole on inner side. Clean the buffed area & apply chemical vulcanizing solution
in the buffed area and in the hole.
• Apply soap water for smooth sliding -in of the wheel rim inside the tyre beading portion.
When a tire rim is wet or a tire seems under-inflated, check for any abnormalities on the tire and repair if necessary.
•
Do not use lever or hamrage for demounting the tyre otherwise it breaks the bid or damage the rim.
•
Tyre mounting /demounting must be done only with machine to avoid rim damage.
•
Always use a new TUBELESS tyre that is proper for tire size when replacing.
•
Correct the tyre pressure as per specification.
•
13. REAR WHEEL/SUSPENSION
13-0 DRIVEN FLANGE
13-1 SHOCK ABSORBER
13-3 SWINGRAM
13-4
13-9
13-12
13-13
13
13-1