Honda CB HORNET 160R 2015 Shop Manual page 157

INSTALLATION
Install the new gasket and dowel pins.
Install the left crankcase cover and tighten the bolt in a
crisscross pattern in several steps.
Tighten the choke cable stay bolts (2 nos.) to the specified
torque.
TORQUE: 9 N.m (0.9 kgf.m, 6.6 Ibf.ft)
Route the neutral switch wire to the left crankcase grooves.
Install the left crankcase rear cover (page 6-5).
Connect the alternator 2P connector and ignition pulse
generator wire connector.
Install the left side cover (page 2-3).
GASKET
BOLTS
LEFT CRANKCASE COVER
CHOKE CABLE
STAY/BOLTS
IGNITION PULSE
GENERATOR
CONNECTOR
ALTERNATOR
DOWEL
PINS
NEUTRAL
SWITCH WIRE
ALTERNATOR 2P
CONNECTOR
10-3