Table of Contents
Advertisement
MAINTENANCE
REAR BRAKE
DISC TYPE:
Inspect the brake hose and fittings for deterioration, cracks
and signs of leakage.
Tighten any loose fittings.
Replace hoses and fittings as required.
Refer to the brake bleeding procedures (page 14-4).
BRAKE LIGHT SWITCH
The front brake light switch does not require adjustment.
•
Hold the brake
Adjust the rear brake light switch.
light switch body
•
and turn the
Remove the right side cover.
adjuster. Do not
Adjust the brake light switch so that the brake light comes
turn the brake
on just prior to the to the brake actually being engaged.
light switch
body.
If the light fails to come on, adjust the switch so that the
light comes on at the proper time.
HEADLIGHT AIM
Place the motorcycle on a level ground.
Adjust the
headlight beam
Adjust the headlight beam vertically by loosening the
as specified by
headlight adjusting bolt.
local laws and
After adjusting the headlight aim, tighten the headlight
regulations.
adjusting bolt to the specified torque.
TORQUE: 2 N·m (0.2 kgf·m, 1.4 lbf·ft)
CLUTCH SYSTEM
INSPECTION
Check the cable and clutch lever for any looseness,
excessive play, or other damage.
Replace or repair them if necessary.
Inspect the clutch cable for kinks or damage, and lubricate
the cable.
Measure the clutch lever free play at the tip of the clutch
lever.
FREE PLAY: 10 – 20 mm (0.4 – 0.8 in)
3-22
FITTING
BRAKE LIGHT
SWITCH BODY
ADJUSTER
ADJUSTING BOLT
10-20 mm (0.4-0.8 in)
BRAKE HOSES
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
