Ignition Coil; Cdi - Honda CB HORNET 160R 2015 Shop Manual

IGNITION SYSTEM
Coat a new O-ring with engine oil and install it onto the
timing hole cap.
Install and tighten the timing hole cap to the specified
torque.
TORQUE:10 N·m (1.0 kgf·m, 7 lbf·ft)

IGNITION COIL

REMOVAL/INSTALLATION
Remove the right side cover (page 2-3).
Disconnect the spark plug cap from the spark plug.
Disconnect the wire connector from the ignition coil.
Remove the bolts and ignition coil.
Installation is in the reverse order of removal.
CDI (CAPACITIVE DISCHARGE IGNITION)
SYSTEM INSPECTION
Remove the fuel tank. (page 2-3).
Disconnect the CDI 6P White connector.
Turn the ignition switch "ON".
Check the following at the wire harness side connector:
Item
Battery
line
Ground
line
REMOVAL/INSTALLATION
Remove the fuel tank (page 2-3).
Disconnect the CDI 4P and 6P White connector.
Remove the CDI from the rubber bracket.
Installation is in the reverse order of removal.
16-6
Specification
Terminal
Red/Black (+) and Battery voltage
body ground (-) should register
Green and body Continuity
ground should exist
TIMING HOLE CAP
O-RING
WIRE CONNECTOR
BOLTS
CDI 6P CONNECTOR
6P CONNECTOR
4P CONNECTOR
CRANCKCASE CAP
IGNITION COIL

CDI

RUBBER
BRACKET