Installing a new chain on badly worn sprockets will cause
a new chain to wear quickly.
Inspect the drive and driven sprocket teeth for wear or
damage, replace if necessary.
Never use a new drive chain on worn sprockets.
Both chain and sprockets must be in good condition, or the
new replacement chain will wear rapidly.
Check the attaching bolts and nuts on the drive and driven
If any are loose, torque them.
Install the drive chain onto the sprockets.
Install the master link and link plate.
Install the retaining clip with its open end opposite to the
direction of chain travel.
Remove the left side cover (page 2-3).
It is not necessary to check the battery electrolyte level
or add distilled water as the battery is a maintenance free
Check the voltage of battery with FBT 50 tester (page 15-3).
Charging the battery (page 15-5).
Install the battery (page 15-3).
Spilled fluid can damage painted, plastic or rubber parts.
Place a rag over these parts whenever the system is
serviced. Keep a spray water bottle while working with
Do not mix different types of fluid, as they are not
compatible with each other.
Do not allow foreign material to enter the system when
filling the reservoir.