Driven Flange Assembly - Honda CB HORNET 160R 2015 Shop Manual

DRIVEN FLANGE ASSEMBLY

DRIVEN FLANGE
DRIVEN FLANGE BEARING
Pack new bearing cavities with grease.
Drive in a new bearing squarely until it is fully seated.
TOOLS:
Driver 070GD-001I100
Attachment. 42 x 47 mm 070GD-002I160
Pilot, 15 mm 07746-0040300
DRIVEN SPROCKET
Install the driven sprocket nuts with the chamfered side
facing out.
Install the nuts and tighten them to the specified torque.
TORQUE: 64 N.m (6.5 kgf.m, 47 Ibf. ft)
BEARING
OIL SEAL
STUD BOLT
64 N.m (6.5 kgf.m, 47 lbf.ft)
REAR WHEEL/SUSPENSION
NUTS
13-11