Driven Flange; Driven Sprocket - Honda CB HORNET 160R 2015 Shop Manual

REAR WHEEL/SUSPENSION
DRUM TYPE
Install the brake panel assembly from the right side of
Do not apply
wheel hub.
grease on the
brake drum and
Install the driven flange assembly (page 13-11).
shoe linings
Slide the rear wheel such that the slot given on panel could
PROTRUSION
align with the protrusion given on swingarm and install the
drive chain.
BRAKE PANEL SLOT
Hold the wheel up and Install rear Axle shaft from left
RIGHT ADJUSTING PLATE
AXLE NUT
hand side. Install Adjusting Plates and screw axle nut to
specified torque.
TORQUE: 88 N.m (8.97 kgf.m, 64.9 Ibf. ft)
Install rod spring and after pushing down the brake pedal
connect the brake rod by inserting it into the Joint Piece.
Tighten the adjusting nut at the end of the rod.
ADJUSTING NUT
Adjust brake free play (page 3-22).
Install drive chain (page 3-18).
ROD SPRING
JOINT PIECE

DRIVEN FLANGE

AXLE SHAFT
AXLE NUT
REMOVAL
Remove the rear wheel (page 13-4).
RIGHT ADJUSTING
PLATE
DISASSEMBLY/INSPECTION
SIDE COLLAR
DUST SEAL

DRIVEN SPROCKET

Remove the side collar and dust seal.
13-9