Camshaft - Honda CB HORNET 160R 2015 Shop Manual

CYLINDER HEAD/VALVES
Install a new cover packing into the cylinder head cover
groove.
Install the cylinder head cover onto the cylinder head.
Install and tighten the head cover bolts to the specified
torque.
TORQUE : 10 N.m (1.1 kgf.m, 7.3 Ibf.ft)

CAMSHAFT

REMOVAL
Remove the following:
– Spark plug (page 3-7)
– Choke cable stay (page 10-2)
– Cylinder head cover (page 7-4)
Remove the head cover cylinder L–side by removing bolts
(3 nos.).
Make sure the piston is at TDC (Top Dead Center) on the
compression stroke (page 3-9).
Remove the tensioner lifter plug and O-ring.
Turn the tensioner shaft clockwise with the stopper tool to
retract the tensioner, then insert the stopper fully to hold
the tensioner in the fully retracted position.
TOOL:
Tensioner lifter stopper
7-6
AIR SUPPLY HOSE
L COVER
070MG-0010100
PACKAGING
O-RING
HEAD COVER
BOLTS
BOLTS
PAN SCREW
O-RING
STOPPER TOOL