Brake Pedal - Honda CB HORNET 160R 2015 Shop Manual

Check the pad spring for damage and replace it if
necessary.
Install the pad spring onto the caliper body.
INSTALLATION
Lubricate the
Install the rear brake caliper bracket assembly onto the
pad pin with
swingarm by aligning the bracket slot with the boss on
the swingarm.
silicone grease.
Install the rear wheel (page 13-8).
Install the brake pads (page 14-7).
Fill and bleed the rear brake hydraulic system.

BRAKE PEDAL

REMOVAL (CBS)
Remove the right side step holder by removing swing arm
pivot nut and right side step holder bolt.
Unhook the rear brake pedal spring.
Unhook the rear brake light switch return spring.
Unhook the cotter pin from pin D joint and brake pad
holder shaft.
Remove the brake pedal.
PAD SPRING
BRACKET
BRAKE CALIPER
RIGHT STEP
HOLDER
BOLT
REAR BRAKE
LIGHT SPRING
PEDAL SPRING
BRAKE SYSTEM
OIL BOLT
SEALING
WASHERS
NUT
COTTER PIN
COTTER PIN
BRAKE PEDAL
14-27