Non Cbs Front Brake - Honda CB HORNET 160R 2015 Shop Manual

BRAKE SYSTEM
ASSEMBLY
Apply clean brake fluid to new piston and dust seals, and
install them into the seal grooves in the caliper cylinder.
Apply clean brake fluid to the caliper pistons, and install
them into the caliper cylinders with the opening side toward
the pads
Install the pad spring onto the caliper body.
Apply grease to the inner surface of brake caliper pin boots,
and install them into the caliper body.
Install the caliper bracket into the caliper body..
INSTALLATION
Install the brake caliper to the right fork leg so that the disc
is positioned between the pads.
Install and tighten new brake caliper mounting bolts to the
specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Install the brake hose to the brake caliper with the oil bolt
and new sealing washers.
Rest the hose joint onto the stoppers, and tighten the oil
bolt to the specified torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Install the brake pads (page 14-7).
Fill the brake fluid, and bleed the air for the hydraulic
system (page 14-4).

NON CBS FRONT BRAKE

REMOVAL
Drain the brake fluid from the hydraulic system (page 14-3).
Remove the brake pads (page 14-7).
Remove the brake hose by removing the oil bolt and
sealing washer.
Remove the brake caliper mounting bolts and brake caliper.
14-16
PISTON
SEAL
CALIPER
PISTONS
PAD RETAINER
CALIPER
BODY
BRACKET
PIN BOOT
BRAKE
HOSE
OIL BOLT
SEALING WASHERS
BRAKE
HOSE
SEALING
OIL BOLT
WASHERS
DUST SEAL
CALIPER BRACKET
CALIPER
PIN BOOT
PAD SPRING
BOLTS
BOLTS