Stator/Ignition Pulse Generator - Honda CB HORNET 160R 2015 Shop Manual

ALTERNATOR
Install the starter motor into the left crankcase cover and
While installing
onto the crankcase .
the starter motor
cable, route the
Install the mounting bolts with the ground cable, and tighten
wire harness
the bolts.
properly.
Install the stater motor cable and terminal nut onto the
motor terminal and tighten the nut.
Install the rubber cap over the motor terminal properly.
STATOR/IGNITION PULSE
GENERATOR
REMOVAL
Remove the left crankcase cover (page 10-2).
Remove the flange bolts (3 nos.), wire guide and ignition
pulse generator.
Remove the grommet.
Remove the three flange bolts and stator from the left
crankcase cover.
INSTALLATION
Install the stator.
Install the three bolts and tighten it.
TORQUE: 10 N·m (1.0 kgf·m, 7.3 lbf·ft)
10-16
STARTER MOTOR
RUBBER CAP
CABLE
GROUND
CABLE
BOLTS
FLANGE BOLTS
GROMMET GUIDE
STATOR
BOLTS
STATOR
BOLTS
TERMINAL NUT
IGNITION
PULSE
GENERATOR