Honda CB HORNET 160R 2015 Shop Manual page 232

REAR WHEEL/SUSPENSION
WHEEL BEARING
Pack new bearing cavities with grease.
Drive in a new left side bearing squarely with the sealed
side facing up until it is fully seated.
Apply a thin coat of grease to the distance collar and
install it.
Drive in a new left side bearing with the sealed side facing
up.
TOOLS:
Driver
Attachment. 42 x 47 mm 070GD-002I160
Pilot, 15 mm
INSTALLATION
DISC TYPE
Install the brake disc.
Install and tighten the brake disc mounting bolts and apply
thread lock in a crisscross pattern in 2 or 3 steps.
Install the side collar and dust seal.
Install the wheel rubber dampers.
Be careful not
Carefully hold and slide the rear bracket assembly on the
to damage slot given on rear bracket assembly by aligning with the
the brake
protrusion given on swingarm and install the rear wheel
pads while and drive chain.
installation.
Install the driven flange, adjusting bolts & swing-arm washer.
Slide the disk towards the engine to install rear wheel
between the brake pads. Hold the wheel upwards and
install axle shaft from swing-arm to the left side. Install axle
nut and tighten to specified torque.
TORQUE: 88 N.m (8.97 kgf.m, 64.9 Ibf.ft)
Check for the chain slackness.
13-8
070GD-001I100
07746-0040300
ATTACHMENT
DUST SEAL
BOLTS
SIDE COLLAR
BRAKE CALIPER
RIGHT ADJUSTING
BRAKE DISC
RUBBER DAMPERS
AXLE NUT
AXLE
SHAFT
PLATE